Additional logotype in drawing templates

The Design Tool makes it possible to use an additional logotype in the drawing template. An additional logotype will be displayed to the left of the drawing template head.

Note: It's not possible to remove or replace the original FlexLink logotype in the template head.
 

Requirements of the logotype file

• It must be in a DWG format
• It must have a size of at most 72 mm x 52 mm

To set an additional logotype

1. Go into Drawing mode
2. Select the drawing frame that should display the logotype
3. Click on Drawing Template - Edit to open the editor of the drawing template.
4. Check the Additional logotype check box and click Browse to select the file.
5. Press OK to load the logotype into the drawing template.

To remove an additional logotype

1. Go into Drawing mode
2. Select the drawing frame that should display the logotype
3. Click on Drawing Template - Edit to open the editor of the drawing template.
4. Uncheck the Additional logotype check box and press OK.